satic pressure tranducer

HVAC questions and problems within commercial installations.

Moderator: juster

Post Reply
Posts: 2
Joined: Tue Jan 04, 2011 10:04 pm

- satic pressure tranducer

Post by juniorkarrie » Sat Jan 15, 2011 1:12 pm

I worked on 35 ton Trane Intellipak just the other day, and in this instance the Humidity control was controlled in one of two places. First the thermostat was programmed for humidity control with fan variations. Second there was seperate a Humidty control sensor located in the Return air Just before the Blower Assembly. As far as the Static Pressure Tranducer, well if it was factory installed, then your sensor should at the supply air veins past the Evap, Heat Exc, or Strips. If The Static pressure tranducer was not factory installed Then contact the Tech of startup and installation or the Duct design engineer beacause only they can tell you depending what perticullar duct there running placement might have been key. Hope this helps you.

New Contributor
Posts: 4
Joined: Tue Feb 13, 2018 12:41 pm

- satic pressure tranducer

Post by JustMike » Tue Feb 13, 2018 1:17 pm

Typically, static pressure transducers or sensors are not factory installed. They are shipped loose to be installed in the duct work. The static pressure transducers are usually installed 2/3 of the way down the main duct. The placement being further down into the duct is important to maintain enough air at the end of the duct runs.

Post Reply